Hi! That you are now check about automotive led light strips item exactly where you are going to find the evaluations, videos, links and photographs which will surely spark your interest. This website give information that you will need to have. There is a complete array of resources which are waiting to be found. You can also carry on reading and search far more testimonials or products as beneath. We have fascinating sources that were gathered by our specialists in automotive led light strips .hope you will get the most effective critiques and buy the proper item about automotive led light strips .
Reviews: customer reviews...
List Price: unavailable
Sale Price: Too low to display.
No description available.
No features available.
There was an error connecting to the Amazon web service, or no results were found for your query.
If you’d like to know further about %keywords%, you might click on the resources to lead you to quite a bit a lot more information and facts and details. You could also make use of the search box to further lead you to other articles. If you want to contribute to this web site,we would adore to hear your recommendations! It could be terrific to possess you share your thoughts about %keywords%. Truly really feel absolutely no cost to send an e-mail to us.
Tina Jay asked Installing LED light strips in my Ford?
Alright, so I bought Pilot Automotive brand 12 Volt FLEX-LITE LED light strips and I'm going to install them myself in the driver side and passenger side foot wells. The instructions say I need to attach the black wire to a chassis ground (which someone was saying was any bare metal bolt/screw in the car, is that right?).Then I need to attach the black wire with the white stripe to a power source but I'm not sure what EXACTLY I'm looking for. (I drive a '95 Ford Taurus GL by the way). I know about my fuse box and everything, I guess my main question is: will I need to buy a fuse tap that I attach the wires to so they go directly into the fuse box or is there a way to do it without one? If I DO need a fuse tap, the one I found it says is for "up to" 32 volts, can I use that and my lights still work? Please help! Oh by the way, I want the LEDs to come on when I start my car. I feel really helpless lol.
And got the following answer:
First of all, yes, chassis ground in a car / truck / van is usually any bolt, screw, etc. that seats firmly into the metal of the body or frame. There are a couple of tricks to that pony though. Any screw, bolt, etc. that isn't painted / rusted / corroded / plain gross beyond recognition. Bright and shiny or at least clean is good to great. Secondly, not all screws and / or bolts will work if they don't directly hold the wire terminal or bare wire against metal tightly. For instance, a screw holding a plastic trim panel may not make adequate ground unless the terminal ring is seated around the screw beneath the panel so it is pressed firmly into the metal beneath. Getting a good ground will depend on bare metal to bare metal and a certain surface area, not just the one side of the screw head touching it lightly. On the fuse panel, there should be a threaded stud with a nut on it that is labeled accessory post, accessory terminal or just accessory. This may be spelled out, numbered to a reference sheet or diagram or abbreviated in some odd manner. It amounts to the same thing, a sign saying "Here is 12 V DC available for use with accessories when the ignition is in the run or accessory position!". That is where I would attach the LED strips + 12 V DC wire (black w/ white stripe). PLEASE NOTE: not all accessory terminals are fuse protected, so check the owner's manual or online for maximum allowable amperage and / or fuse rating. If no fuse exists in the terminal, then buy and use an appropriately sized inline fuse holder. They are a lot cheaper than replacing the car that burnt up because of LED strips shorted by rain, snow, wear or overload.